General Discussion Archives - Page 2 of 2315

I'm looking for either a manual hydraulic lift table. For example when fitting drawers to a dresser frame, finishing, etc., to avoid having to bend down to the floor. Anyone…

Sorry, I didn't know where to put this. I'm going to be making kitchen cabinets for my home. They will be all out of either cherry or elm. All of…

Folks, my Sawstop had a calamity and I don't know what to do. It's a 10-year-old model and has seen me through almost 100 projects with no trouble until today.I…

Hi all, I am finalizing a chair design in Sketchup and wanted to get your thoughts on the M&Ts on my rear legs. The chair will have a traditional weaved Danish…

I paid for a digital subscription so I could get old plans, etc. I'm looking for the complete, detailed plans and parts list for the modern Adirondack chair from issue…

I've had this for 15 years using a PC router that has died. Just got a new Bosch(1617EVS) and Dewalt(1 3/4hp) router. The Leigh dovetail bits are 8mm and need…

Hello,I am making a table for my son, using some salvaged maple. However, we had to fall an old fir tree on our property and he is hoping I can…

I have a few questions for those who have built a Chippendale desk/secretary, preferably a block front with six shells, swan neck cornice molding, a highly detailed interior desk gallery,…

I want to learn to steam bend, and landing nets seem to be a great project for it.I'm thinking of using 1/4" laminate strips (ash, cherry, walnut, sapele) with an…

I had been a subscriber for years. I asked a question on getting plans on a particular project, but no response. I think I am still a subscriber, but I…