Jigs, Fixtures, Tips & Tricks Archives - Page 2 of 70

Curious how people like to make these clamping jigs, if at all.Its not how I usually clamp miters but I’m making 6 waterfall benches and need some extra clamping pressure(None…

This question is for anyone who might have an MLCS router extension table installed in their table saw like I do.  I am want to install a traditional router lift (e.g. JessEm, Rockler,…

Hi I have this table made with plywood and solid red oak attached on the sides of plywood as a “thick(3/4”) veneer”. long story short I don’t like the look of it…

I have no room for a miter guage slot on my routertable what can I do

Had some of this in "Power Tools" forum earlier, probably the wrong place.-  Why do all the router table "builds" that I see have double fence slots? Why isn't Bob…

I saw a discussion about drill press MORTISING vs. MORTISING machine. I am in the habit of specific set ups.that is, when frequently revisiting an operation, to leave the tool…

Hi,So I am making a bunch of cabinet doors. I am doing mortise and tenons for the joinery. I have a profile on the inside (just a 25° chamfer), and…

When I fill in cracks or larger voids, I use a black epoxy. Then I come back after first sanding grits and fill the little microvoids from bubbles or whatever I…

I have always done miter corners with a miter sled on the table saw.  Then cut a slot with the table saw to add a spline.   But this time…

I'm building a round coffee table, shaker style, out of cherry.  The top will be 36" in diameter, the legs at the top will be 1.5" square, tapering down.  I…