John White Archives

I have a Delta X5 planer jointer. I have a problem of snipe as I finish running boards through the machine. I have checked with a straight edge that the…

Hello John, I have been asked to bid a Trestle type solid linear Q.S. White Oak table @ 4' x 9' with a roughly 2 to 3"  running length wise…

I'm looking to buy an 8" jointer.  All the reviews I've read say a longer bed, specifically a longer infeed table, matters.  However, 12" jointers typically have much shorter beds…

Any sources of information/instructions on realigning the table on a Delts DJ20 jointer (parallelogram adjustments)?  I have determined that the table cross bars are mounted in eccentric bushings, but tinkering…

Hi John,   Not sure where to post this, possibly I could get some input?  

Hi john, is there a "rule of thumb" to determine size, length, and spacing for dowels when joining the edge of boards?  I specifically want to join two 1.75" slabs…

My dad built this table in wood shop lcass back in the late 1930s. My brother has the table in Oregon and I am in Kentucky. I would like to…

I have an arbor project that requires installing the lattice onto the posts with a mere six inches wide to drive a 3" screw.  So I have 3" or less…

I am interested in building the router table in the table saw. I have a Sawstop with a 52 inch fence so this should fit perfectly. My questions are you…

Hi John,             I would like to know the process for edge jointing a piece of walnut 9ft long by 1inch thick. I get a nice long curl for the…